How to replace the cutting blade of angle grinder

　　How to replace the cutting blade of angle grinder

The angle grinder has a wide range of uses, but you must pay attention to how to use it correctly. So how to replace the cutting blade of the angle grinder, follow the editor to find out.

1. How to replace the cutting blade of angle grinder

1. Unscrew the screw plate of the angle grinder and remove the original cutting blade;

2. Install the cutting disc that needs to be replaced, and push the slot down to press the inner hole of the grinding surface;

3. The inner hole of the grinding disc needs to be inserted into the bayonet of the pressure plate;

4. Press the head lock and use a wrench to tighten the anti-wire cover.

2. What should you pay attention to when using the angle grinder?

1. Before using the angle grinder, you need to check its various accessories to see if there is any damage or aging. If it is present, it must not be used immediately. It must be repaired first to ensure sufficient safety.

2. During the cutting or grinding process using an angle grinder, other unrelated personnel are not allowed to approach, and there must be no flammable or explosive items within the construction area. Moreover, construction workers are strictly prohibited from using angle grinders in the direction of people.

3. When the grinding wheel is used up, it needs to be replaced with a new one. At this time, construction cannot be carried out directly, but the power supply must be cut off before replacement work is done to avoid unnecessary dangers caused by pressing the wrong button during the replacement process.

4. If you are constructing in a relatively dangerous area, if there are flammable items in the surrounding area, prepare several fire extinguishers within the construction scope to prevent fires and minimize losses as much as possible.

5. The angle grinder should not be used for too long. When it is used for about half an hour, it needs to be stopped for 10 to 20 minutes. After it cools down, it can be used again to avoid equipment failure due to excessive temperature. damage, even causing work-related injuries.